INVITATION TO ATTEND TWO-DAY COURSE ON “FINITE ELEMENT SIMULATION AND STRUCTURAL ENGINEERING APPLICATIONS WITH ABAQUS”

NVITATION TO ATTEND TWO-DAY COURSE ON “FINITE ELEMENT SIMULATION AND STRUCTURAL ENGINEERING APPLICATIONS WITH ABAQUS”

Dear Prof./ Assoc. Prof./ Dr./ Sir/ Madam,

 

You are cordially invited to attend the two-day course of FINITE ELEMENT SIMULATION AND STRUCTURAL ENGINEERING APPLICATIONS WITH ABAQUS”
organized by ICT CICT Training and UTM-HPC, Centre for Information and Communication Technology (CICT), UTM Johor Bahru, Johor.

 

This course will be held on 14th & 15th August 2017 (Monday & Tuesday) at D07, Level 4, Training Room, CICT UTM Johor Bahru, Johor, Malaysia.

 

Our registration fees as follows:-

  1. RM 300 for UTM (staff/students)
  2. RM 400 for outside UTM


Finite Element (FE) method is a numerical approach made available for engineers to perform stress analyses on engineering components and structures. The method has been made available, in the form of commercial FE analysis software as essential design and analysis tool for engineers. The software can be employed for solving problems involving complex geometries, combined loadings and non-linear materials responses where analytical solution is limited or often nonexistent. Being a general purpose design and analysis software, its utilization requires a thorough understanding of the simulation methodology. This includes continuum discretization, representation of boundary conditions, selections of material models, element mesh optimization, model validation and physical interpretation of numerical results. These requirements rest beyond traditional university-level courses on theoretical aspects and numerical implementation of the method.

At the end of the workshop, participants should be able to
–  Describe steps in solving engineering problems using FE method.
–  Identify essential requirements in performing engineering simulation of structural problems.
–  Set-up FE model of engineering structures for solution using Abaqus software.
–  Interpret, evaluate and present FE results for displacements, strains and stresses.

For detail, please see the following link: Abaqus Workshop. Please use the registration page to register for ABAQUS workshop. Please do not hesitate to contact us if you require any further information.

For further enquiries, call Aziz  (+607-5532214) / Anwar (+607-5533095) or email to ict-training@utm.my

 

Thank you.

 

Best regards,

Customer Relationship Management (CRM),

Center for Information and Communication Technology,

Universiti Teknologi Malaysia.

System : http://aduan.cict.utm.my | Email : aduit@utm.my   |  Phone No : 07-5532136